Vital Wrap System

The VitalWrap System consists of three components; a control unit, a tubing set, and a thermal fabric wrap.  The control unit manages the temperature of water used by the system to supply heat or cold to the fabric wrap attached to the body.  By pumping the water through a heat-echanging bladder inside the wrap, the control unit warms or cools the water to match the proper temperature setting, delivering precise and safe thermal therapy.

Once the control unit is turned on, the cooled or warmed fluid is passesd through the tubing set, to the wrap.  As it circulates into the wrap from the control unit, the fluid either applies heat to warm the treatment area or draws in away for deep cooling.  The fluid then flows back into the control unit, where it is re-cooled or re-warmed before cycling back into the wrap.  Compression is delievered through the wrap itself, and can continue even if the user chooses to disconnect the tubing set and control unit. 

The VitalWrap System is designed so that the user can apply thermal therapy for extended periods of time.  This provides tremendous benefit to the injury site beyond the normal application periods of conventional therapies, such as heating pads and cold packs.  The typical transition time between warm and cold setting in the temperature range is about one minute. 

Product Specifics:

Size:  8" diameter x 13.5" H

Weight:(dry) 5 lbs.

Fluid Tether: 8 feet

Type: Manuel user control

Range: 40 degrees to 105 degrees F.

Contrast Therapy Transition Time: 1 minute typical from extremes in temperature range

Operating Period: 2-6 hours typical continous use

Thermal Cutout: 117 degrees C.

Reservoir Capacity: 1.1 Gallons

Reservoir fluid: Ice Water

Flow Rate: 5.5 gph

Maximum Pressure: 18 psi

Electrical System: 100, 120Vac, 50/60HZ, or 220-240Vac, 50Hz

Power: 300W

Simply complete and submit this form, and we will contact you with more information.